-
BALLY 50 GR It adheres wicks exceptionally with all kinds of gaskets used in leather, rubber, formica, artificial wood, glass, porcelain, bakelite and metal plate and automotive, industry.
-
15-20 minutes by applying in sufficient amount.
-
for a period of time, it is allowed to dry and then glued.
-
It is an elastic adhesive resistant to water,heat and aging.
-
The surfaces to be glued have to be dry, clean and oil-free, and if possible, they have to be cleaned with sandpaper.
-
Materials should be at normal temperature.
-
The best temperature is 18ºC -20ºC. It is not recommended to work below 15ºC.
-
The optimal moisture content of the board is 8-12%.
-
Adhesive has to be applied to both surfaces to be adhered.
-
The time required for the adhesive to dry is 10-20 minutes.
-
The drying time varies depending on the amount of adhesive applied, the temperature and the ventilation time.
-
It has to be waited for the wetness of the adhesive to pass for the bonding process.
-
Usage amount: 125-150 g / m².
-
On surfaces with a sufficient amount of adhesive, a continuous film layer is observed.
-
It is not possible to correct the surfaces that are in contact with each other by opening or sliding them on each other.
-
A stronger bond is obtained on the pressed adhesion surfaces.
-
Press pressure is 0.3 N / mm² for flexible materials and 0.5 N / mm² for hard materials.
-
Press time of a few seconds is sufficient.


