MOLD and MOISTURE PAINT ( 1 Kg) - It is a very strong synthetic insulation paint produced by modifying with special chemicals and polymers to eliminate moisture and humidity problems caused by natural conditions on the interior and exterior walls of buildings.

It can be applied to all kinds of damp or dry walls, painted and unpainted surfaces.

Thanks to its excellent alkaline and moisture resistance, it prevents moisture and moisture formation on the walls and destroys them, if any.

Its adhesion resistance to all kinds of surfaces is extremely strong, it does not blister, and its resistance to chemicals is quite good.

It is not affected by UV and rain, water, salt.

It is used in interior and exterior walls, floods of buildings, basements, garages or cellars, interior walls facing north and in areas where there is a lot of moisture and humidity.

It forms film layers that show excellent moisture resistance on the surface where it is used.

Clings too tightly to the surface, even if the paint or wall is damp.

It is not affected by salt water and salt vomiting.

Due to this feature, it is also used to solve the problem of paint bubbling in the floods of buildings.

Bars Mold and Moisture Paint penetrates the wall where it is applied and dries the moisture inside thanks to its special chemicals.

Bars Mold and Moisture Paint has no side effects on the applied surface.

Surface Preparation: Bars Mold and Moisture Paint is ready to use, does not require primer.

Before the application, darkening formations on the surface have to be cleaned.

The application surface may be damp, damp or dry.

It can be applied to all kinds of unpainted surfaces.

If there are raised parts only on painted surfaces, the surface to be applied has to be cleaned and a solid surface has to be obtained by using appropriate repair mortar.

Application Method: Bars Mold and Moisture Paint in its original packaging should be mixed thoroughly for 3 minutes by opening the lid.

After the mixing process is completed, it is recommended to apply to the existing surface with a brush, a suitable sprayer or especially a synthetic epoxy roller without thinning the product.

One coat should be applied and after waiting for 24 hours, the second coat should be applied.

Ventilation of the application areas has to be done well, masks, gloves and protective glasses have to be used during the application.

CONSUMPTION: 7-9 m²/Lt PACKAGING in one layer depending on the absorbency of the surface: 0.75 Lt (1 Kg) and 5 Kg Tin