-
INSTALLATION and OPERATING MANUAL - Before installing the lock on the door, remove the tongue with a thin screwdriver into the tongue rotation hole on the back of the lock to adjust it according to the RIGHT or left opening door.
-
Move the tongue to the RIGHT or LEFT position with the help of a hand.
-
Mark the place where you will install the lock.
-
The lockbox length is 180 mm.
-
Open the slot with an 18 mm mill.
-
Drill the holes of the handle and key with a 20 mm drill on the vertical axis by taking measurements from the forehead surface of your door.
-
Mount your lock with a 3.5x25 mm chipboard screw.
-
Install the locking striker with 3 pieces of 3.5x20 mm chipboard screws.
-
LOCK arrangement dribbling TYPE MECHANICALLY USED IN RESIDENTIAL DOORS INSIDE THE BUILDING: manual LOCKING WITH INTERMEDIATE LOCKING POSITION PRODUCTION DATE: 02/2021 TESTS and VALUES REQUIRED FOR CLASSIFICATION - resistance TO lateral force ON the tongue slide IS 2kN.
-
To operate the lock with the key without applying lateral force - The maximum torque applied to the hub to operate the lock is 10 kN and the maximum torque required is 1.2 kN.
-
The tongue components of the lock and the movement limit stops are resistant to a torque of 20 Nm - The movement resistance of the tongue slide is a minimum of 12,500 cycles.
-
The maximum door mass that the lock can operate is 100 kg -The maximum door closing force that the lock can operate is 15 N.
-
Not designed for fire resistant doors.
-
Lock slide protrusion min.
-
10 mm:


