-
Closed Case Water Purifier Multi Mineral 6-Piece Filter Standard Membrane Set 6 FILTER REPLACEMENT and WASHING STEPS 1- Close the water inlet valve of your device, open your treatment tap and empty your tank.
-
2- After completely draining the water inside the tank, close the valve of your tank.
-
(If the water in your tank is not completely drained in this section, read the NOTE.
-
) 3- Install the filters by paying attention to their inlets and outlets as shown in the diagram.
-
4- Place the membrane carefully in its place.
-
Place the double black sealed part so that it fits inside the membrane container.
-
With the help of hook and loop/pliers, hold the outer white plastic part and push it slightly to the right and left.
-
Remove the hose from the outlet of your filter 5- 2, open the valve of your mains water and perform your pre-filter washing.
-
You can also tap around the filters while providing water flow for 2 minutes.
-
Close your mains valve and replace the hose.
-
6- Open the valve of your tank, the valve of your mains water and your purifier tap.
-
7- With the help of a light, check your connection parts for water leakage.
-
8- At first, thin and black water will flow from your faucet.
-
At this stage, lightly tap around your sweetener filter, then close the lid of your appliance and place it in its place.
-
9- Turn off your purifier tap and turn on your purifier tap again after an average of 1 hour and drain the water accumulated in your tank.
-
10- After filling and emptying in this way, you can drink your water with peace of mind.
-
Thank you for choosing us, we wish you a healthy day.
-
NOTE: If the water in your tank is not completely drained, the air in your tank is reduced or exhausted.
-
Afterwards, you can contact us and get detailed information from our technical support team about the procedure you will perform to breathe air.


